8
Installation Instructions
Site Selection
Before selecting a site, please read the Safety Information, Manufacturer’s Warnings and
the relevant indoor/outdoor sections.
Your Roto Spa is completely self-contained and portable. It can be set up on a patio, deck
or even indoors.
The dimensions of your Roto spa are 33” (84cm) high X 78.5” (199cm) wide.
1.
Structure:
The Roto Spa should always be placed on a structurally strong,
relatively smooth and level surface.
2.
Drainage:
do not place the Roto Spa in an area where water will puddle around
the tub.
3.
Electrical:
Allow easy access to the controller situated behind the access panel
for electrical hook up.
Outdoor Installation
Your Roto Spa is totally self-contained and portable. You can place it just about
anywhere you wish; on any smooth surface (tile, concrete, wood, and brick). Verify the
tub is placed on a firm, level well-drained base prior to set-up. If you need to step on
grass or dirt to enter the Roto Spa, we recommend the use of stepping-stones to reduce
the amount of dirt and debris entering the tub.
ANY DAMAGE CAUSED BY THE SPA RESTING ON AN UNEVEN SURFACE WILL NOT
BE COVERED BY THE WARRANTY.
When considering an installation site, always allow for easy access to your equipment.
The installation site should also allow enough room to completely remove and store the
spa cover during used.
Indoor/Basement Installation
Water splashing on the floor during use may cause a walking hazard and/or structural
damage unless good drainage is provided. Proper building materials must be used in the
area surrounding and beneath the tub. Take into consideration the room humidity, which
will exist due to high temperatures. Providing natural or forced ventilation in the room
will help maintain comfort and minimize moisture damage to the surrounding
environment. Consult an architect for aid in designing your indoor Roto Spa room.
Note: Using your spa for 15 to 20 minutes gives off the same moisture/condensation as a
15 to 20 minute shower, so a proper bathroom fan should be installed.