9
Installation Instructions
Site Preparation
As a homeowner, it is your responsibility to provide a suitable, level foundation for your
Roto Spa since the delivery crews are not equipped to level or prepare sites.
Keep in mind that placing the spa on grass or dirt may increase the amount of debris that
is inadvertently brought into the spa water on users’ feet.
Caution:
Your Roto Spa is not intended to be installed below ground level.
Deck Installation
You must know the deck’s maximum load capacity to be certain you deck can support
you spa. Consult a qualified building contractor or structural engineer. Your Roto Spa
when filled with water has a maximum weight of 3300 lb or 7260 kg.
Electrical Connection
Your Roto Spa comes ready to install using an 110V 15amp corded connection complete
with an inline GFCI ready to plug into a dedicated 15amp household circuit.
Roto Spas have been designed to meet the maximum safety requirements to prevent
electrical shock. Improper wiring may cause electrocution, risk of fire, risk of injuries,
and damage to the equipment. Never use an extension cord to connect the Roto Spa to the
power source.
Starting Your Roto Spa
Caution: The control module must never be operated without water in the Roto
Spa; serious damage to the heater and/or pump may result.
NOTE: Never fill your spa with soft water. Soft water makes it impossible to
maintain the proper water chemistry and may cause the water to foam.
After your Roto spa has been positioned follow these instructions for start-up.
The same steps apply each time the Roto Spa is emptied and refilled:
1.
Ensure electrical power is off.
