-11-
Step 9
Round the right bottom corner and begin moving
the bit upward while applying light pressure left
toward the box until you meet initial upward cut.
Push Spiral Saw power tool switch to off.
Step 10
The completed box, executed quickly, neatly and
in a fraction of the time taken by other methods.
These step-by-step instructions are
generalized to acquaint you with the Spiral
Saw power tool operation. After some practice,
you may develop a motion technique with
which you are more comfortable. However, you
must always begin the cut somewhat centrally,
and MOVE THE SPIRAL SAW™ POWER
TOOL ONLY COUNTERCLOCKWISE to take
advantage of the “hugging” action of the
rotating Zip Bit along the contours of the
template. Remember to use a smooth
continuous motion.
-10-
Step 5
Pull the Zip Bit out far enough to slip it over the
edge of the box so it is now against the outside of
the box.
Step 6
While keeping the Zip Bit in contact with the
outside of the box move the tool counter clockwise
while applying light inward and upward pressure
until you feel and hear it come to the corner. As
you round the corner apply light pressure left and
downward.
Step 7
While moving slowly and continuously along
the top contour you will feel the Zip Bit come to
the next corner. Round the corner and apply
light down and inward pressure until the bottom
corner is reached.
Step 8
Move the Zip Bit right and upward maintaining
light continuous pressure toward the box.
