Acoustic signals
Sound
Message
Meaning
Corrective action
1x beep
Confirmation Command understood, process completed correctly.
-
3x short beeps
Note
Command understood but cannot be executed because the
maximum number of cycles in the time unit has been
exceeded.
Multipoint locking system was actuated too often in
a short time period. Let the motor cool down for
around 2 minutes to prevent damage.
4x short beeps
Note
Calibration push-button was actuated but calibration /
clearance is not possible.
Move the lock of the Eneo C multipoint locking
system to the correct position and recalibrate.
2x two-tone
beeps
Fault
The magnetic contact was interrupted during the locking
process. Either the door was opened again during this period
or the magnet was not positioned / adjusted correctly.
Lock the door again.
Position the magnet correctly and lock the door
again.
3x two-tone
beeps
Fault
Control unit detected excess current in the motor and
stopped.
Remove blocks.
If the door is not running smoothly, contact the
door manufacturer.
4x two-tone
beeps
Fault
The final position of the connecting rod was not reached in
the maximum permitted time of 3 seconds.
No movement noises are audible and no movement
of the lock is visible, motor faulty. Replace the lock.
5x two-tone
beeps
Note
Command from hand-held transmitter is executed but the
hand-held transmitter battery will soon be flat.
Replace the battery
7x two-tone
beeps
Note
Only for Eneo A multipoint locking system.
Calibration current values have either failed to reach or have
exceeded the specified values.
Recalibration required.
Have electrical installation work carried out by
qualified personnel.
Roto Safe Eneo
6 ·
04 / 2019
·
SUG_11_EN_v0
Roto Safe Eneo
Subject to change.
