IQT3 manual – Section: Commissioning - Basic Settings
17
8.1 Connecting to the Actuator
The Rotork Setting Tool incorporating
Bluetooth
wireless technology (Rotork
Bluetooth
®
Setting Tool Pro – BTST) is
shown below. It is identified by the key
symbols being clear and a clear seal
between the top and bottom casings.
The Infra-red only tool has filled
yellow keys and a yellow seal between
casings.
The Rotork
Bluetooth
®
Setting Tool
Pro with the relevant navigation and
configuration keys is shown below.
Up
Down
Back
Select/
Save
Right/
Increase
Left/Decrease
Forward
Connecting to the actuator
using
Bluetooth
The default security set in the actuator
for
Bluetooth
connection is by initiation
using an infra red command. This
means that the user must be in close
proximity and in direct line of sight of
the actuator.
Point the setting tool at the actuator
display window within a range 0.25 m
(10 in) and Press key.
The screen will change to the Main
Menu screen.
Fig. 8.1.1
The Setting Tool will automatically
connect using
Bluetooth
which
takes up to 5 seconds and when
connected will be indicated by blue
lights illuminating on the tool and
in the actuator display window.
Once connected, the tool can be
used without pointing it at the
actuator display window.
Bluetooth
connection will be
maintained while setting tool key
commands are made. After a period
of 6 minutes with no key commands,
Bluetooth
connection will be turned off
and the Setting tool and display blue
lights will go out. To manually turn
off
Bluetooth
connection at any time,
press the setting tool and keys
together.
