18
IQT3 manual – Section: Commissioning - Basic Settings
8.2 Security - Password
The default security level for connecting
to the actuator is by infra-red
Bluetooth
initiation. This requires that the user
is at the actuator within 0.25 metre
distance and in direct line of sight
of the display. For instruction on
connecting to the actuator refer to 8.1.
All actuator settings can be viewed
with the actuator selected to Local,
Stop or remote.
To change an actuator setting, the
actuator must be selected to Local or
Stop and a correct password entered.
If the actuator is selected to Remote
and a setting is selected, the following
warning will be displayed:
Fig. 8.2.1
Select OK to return to settings screen.
With the actuator selected to Local
or Stop and when any function is
selected, the Password screen will be
displayed:
Fig. 8.2.2
The factory set default password
ROTORK is displayed and the OK
key is highlighted.
Press the
key.
The setting screen will again be
displayed. The example below shows
Settings – Limits – Close Settings
with the function
Action
highlighted:
Stopped
Close
Settings
Direction
Clock
Anti
Action
Limit
Torque
Torque
100%
Set Limit
Open
Settings
Action
Limit
Torque
Torque
60%
2/15
LED INDICATION: R = RED, G = GREEN, Y = YELLOW, B = BLUE
Y
Y
Fig. 8.2.3
Press the
key to select.
The function and its setting option or
range will then be highlighted:
Stopped
Close
Settings
Direction
Clock
Anti
Action
Limit
Torque
Torque
100%
Set Limit
Open
Settings
Action
Limit
Torque
Torque
60%
2/15
LED INDICATION: R = RED, G = GREEN, Y = YELLOW, B = BLUE
Y
Y
Fig. 8.2.4
If the user does not wish to change
the function value, press the
back button to escape without
changing.
