IQT3 manual – Section: Health and Safety
5
e.
Only the following approved Alkaline-
Manganese or Zinc-Manganese type ‘AAA’
size batteries must be fitted to the BTST:
- Duracell: Procell MN2400
- Energizer: E92
f.
Always replace all four batteries
at the same time. Always use four
unused batteries of the same approved
manufacturer, type and expiry date code.
g.
Ensure the batteries are fitted with the
correct polarity. The battery polarity (+)
is indicated on the inside of the battery
compartment of the BTST.
7.
The BTST contains no other user
replaceable parts and it cannot be repaired
by the user. If the BTST is faulty or needs
repairing, it must not be used.
1.3 Introduction to this manual
This manual covers IQT 3
rd
Generation
actuators:
IQT
Operation of isolating/
regulating
1
/
4
turn valves.
IQTM Operation of modulating
1
/
4
turn valves.
IQTF Operation of part-turn and slow
speed multi-turn valves.
IQTFM Operation of part-turn and
slow speed multi-turn valves for
modulating duty.
This manual provides instruction on:
• Manual and electrical (local and
remote) operation.
• Preparation and installation of the
actuator onto the valve.
• Basic Commissioning.
• Maintenance.
Refer to Publication PUB002-067
for repair, overhaul and spare part
instructions.
Refer to Publication PUB002-040
for secondary function
configuration instructions.
Using the supplied Rotork
Bluetooth
®
Setting Tool Pro to access the actuator
set up procedures, non-intrusive
setting of torque levels, position limits
and all other control and indication
functions can be made safely, quickly
and conveniently, even in hazardous
locations. The IQ allows commissioning
and adjustment to be carried out with
the main power supply to the actuator
switched on or off.
The setting tool is packed in the
shipping box identified with a
yellow label.
Visit our web site at www.rotork.com
for more information on the IQ, Insight2
and other Rotork actuator ranges.
2. Health and Safety
This manual is produced to enable a
competent user to install, operate, adjust
and inspect Rotork IQT range valve
actuators. Only persons competent by
virtue of their training or experience
should install, maintain and repair Rotork
actuators.
Under no circumstances should
replacement parts be used in Rotork
actuators, other than those supplied or
specified by Rotork.
Work undertaken must be carried out in
accordance with the instructions in this
and any other relevant manuals.
If the actuator is used in a manner not
specified in this manual and any other
Rotork manual, the protection provided
by the actuator may be impaired.
The user and those persons working
on this equipment should be familiar
with their responsibilities under any
statutory provisions relating to the
Health and Safety of their workplace.
Due consideration of additional hazards
should be taken when using the IQT
range of actuators with other equipment.
Should further information and guidance
relating to the safe use of the Rotork IQT
range of actuators be required, it will
be provided on request. The electrical
installation, maintenance and use of
