Keeping the World Flowing
11
10.3 Assembly Configurations
Fig 10.2 Actuator/valve assembling example
The end user is in charge of removing the actuator
from the valve.
Removal shall be performed only by qualified staff,
wearing/using appropriate personal protection devices.
Do not remove the actuator if the valve is blocked
in the intermediate position. Contact Rotork Customer
Service.
To disassemble the actuator from the valve, proceed as
follows:
• Cut off electrical power supply
• Cut off pneumatic supply
• Release any pressure from the control group
• Remove the supply pipes from the actuator
• Remove control and signal lines from electric components
(if any)
• Sling the actuator in line with the instructions given in
section 7.0
• Unscrew bolts or nuts from the stud bolts fixing the
actuator to the valve
• Lift and remove the actuator from the valve
10.0 Installation on Valve
11.0 Removal from Valve
A4
US
US
A4
US
A4
A4
US
Summary of Contents for LP/S Series
Page 89: ...Keeping the World Flowing 89...
