SI manual – Section: Introduction
5
6)
In accordance with the BTST
hazardous area approvals and with the
recommendations from the approved
battery suppliers, the following are
mandatory requirements for safe use:
a)
The inspection or replacement of the
batteries must be conducted in a safe
(non-hazardous), dry area.
b)
The batteries must be removed from
the BTST when it is not expected to be
used for three months or longer.
c)
Discharged batteries must be
removed from the BTST to prevent
possible damage.
d)
The battery compartment of the
BTST must be inspected every three
months for any battery leakage. If any
battery leakage has occurred then the
BTST must not be used.
e)
Only the following approved
Alkaline-Manganese or Zinc-
Manganese type ‘AAA’ size batteries
must be fitted to the BTST:
- Duracell: Procell MN2400
- Energizer: E92
f)
Always replace all four batteries
at the same time. Always use four
unused batteries of the same approved
manufacturer, type and expiry date
code.
g)
Ensure the batteries are fitted
with the correct polarity. The battery
polarity (+) is indicated on the inside of
the battery compartment of the BTST.
7)
The BTST contains no other user
replaceable parts and it cannot be
repaired by the user. If the BTST is
faulty or needs repairing, it must not
be used.
1.3 Introduction to this Manual
This manual provides instruction on:
• Preparation and installation of the
actuator onto the valve
• Electrical (local and remote) and
optional manual operation
• Basic Commissioning
• Maintenance
Refer to Rotork for repair, overhaul
and spare parts.
Refer to Publication PUB021-069
for full configuration, status and
monitoring user manual.
Using the supplied Rotork Bluetooth
®
Setting Tool
Pro
to access the actuator
set up procedures, non-intrusive setting
of pressure levels, position limits
and all other control and indication
functions can be made safely, quickly
and conveniently, even in hazardous
locations. The SI allows commissioning
and adjustment to be carried out with
the main power supply to the actuator
switched on.
Visit our web site at www.rotork.com
for more information on the SI, Insight 2
software and other Rotork actuator ranges.
Summary of Contents for Skilmatic SI 3
Page 39: ...39...
