Smart Positioner
YT-2500 / 2550 / 2501 Series
Product Manual
Ver. 1.34
30
6)
Attach the positioner to the bracket. <
Only fork lever type of YT-2500 / 2550: Fix the clamping pin
(5mm Dia.) into the fork lever slot and insert center pin (2mm Dia.) of the main shaft of the
positioner into the hole of center of the fork lever. The clamping pin will be locked to the fork lever
spring.>
Setting alignment of center of main shaft of the positioner and center of the actuator’s
stem is very important. Poor alignment of the main shaft and the actuator’s stem decreases the
positioner’s durability due to unnecessary forces on the main shaft.
Fig. 3-19: Main shaft center alignment (Fork lever) Fig. 3-20: Main shaft center alignment (Namur)
7)
Tighten the positioner and the bracket with bolts
after checking the positioner’s position.
