Smart Positioner
YT-3100
Product Manual
Ver. 1.19
55
9.11.2
Linear Interpolation (ITP oFF / on)
ITP is used to compensate the linear motion of the actuator into rotary motion of the feedback lever.
Following Auto Calibration, the ITP mode is set automatically to ON when the angle range of the
feedback lever is greater than 20°, but it is set to OFF when this angle is less than 20° or rotary
positioner is used.
The settings below are the process of manually changing the “ITP oFF” to the “ITP on”.
3 seconds
→
→
→
Press <UP> or
<DOWN> button
if the above is not
displayed.
Press <UP> or
<DOWN> button
if the above is not
displayed.
<UP>/<DOWN>
→
<ESC>
3 times
→
9.11.3
Lock of Parameters (Write Protect, W UNLOCK / LOCK)
This function is used to set (LOCK) or disable (UNLOCK) the lock for the parameters. Used to prevent
the stored parameters from being changed.
3 seconds
→
→
→
Press <UP> or
<DOWN> button
if the above is not
displayed.
Press <UP> or
<DOWN> button
if the above is not
displayed.
<UP>/<DOWN>
→
<ESC>
3 times
→
