5
USING YOUR HOT TUB’S CONTROL PANEL
AND FEATURES.
Please see below for information on how to use your control panel and any extra features fitted on your DuraSpa.
Your DuraSpa is fitted with a 2 speed pump as standard which means you will be able to alter the
strength of the jets, to put the pump into manual mode low speed, press the pump button once, push a
second time to put the pump into manual mode high speed. To ensure your RotoSpa retains its
temperature please return to auto mode when not in use.
Your DuraSpa comes with a single colour LED light as standard. To operate the LED light push the up
button once, this will turn it on. If you upgraded your LED light to a Mulitcolour then pressing the up
button 3 times will put the light into a slow cycle throughout the colours, push it a fourth time will put it
into a fast cycle, 5 pushes turns the light off. Pushing the down button will allowing you to choose one set
colour (light must be on for this to work).
Fitted to the topside of your DuraSpa are 2 grey dials. These are called Venturi air controls and will introduce
a small amount of air into the water when flowing through the jets, increasing the pressure and massage
effect. To operate simply twist the dial into the on position. Ensure these are turned off when not in use as it
the air will increase ph. levels and will add cold air into the water increasing running costs.
