INSTALLING THE SUPPORT STRAP
With the Velcro
®
facing up, thread the end of
the strap with the Rotozip
®
logo around the
post near the cord as shown.
Thread the other end through the slot near
the front of the tool. Fold the front flap over
first (1), then fold the end with the Rotozip
®
logo (2) as shown. Press firmly to ensure the
strap is secured.
-8-
BUMP SWITCH (ON/OFF)
This tool is switched “ON” by the bump switch
located on the back of the motor housing
(Fig. 6).
TO TURN THE TOOL “ON” slide the switch
button up or “1” position.
TO TURN THE TOOL “OFF” slide the switch
button down or “0” position.
Hold the tool with both hands
while starting, since torque
from the motor can cause the tool to twist.
!
WARNING
Operating Instructions
MAKE A FEW PRACTICE CUTS
After installing the Bit into the tool and
adjusting your depth guide, you should make
a few practice cuts with the tool before
attempting an actual job.
Step 1: Make certain that the collet nut is
securely tightened before turning the tool on.
Step 2: Hold the tool firmly and turn the tool on.
Step 3: While holding the tool firmly, insert
the bit into the material at a 45° angle (Fig. 7).
Step 4: Slowly bring it to a 90° angle to begin
the cut. The depth guide should be flush to
the material surface (Fig. 8).
Step 5: Steer the tool in a clockwise direction
with slow, steady pressure to make the cut.
1
2
0
1
GENERAL DRYWALL CUTTING INSTRUCTIONS
(See next section for cutting electrical boxes and door/window openings)
FIG. 5
FIG. 6
FIG. 7
FIG. 8
BUMP
SWITCH
(ON/OFF)
RZ 2610955525 10-07 10/11/07 8:19 AM Page 8
