Introduction/Safety/Installation 5
SG80AII
Manual
www.rottlermfg.com
ALWAYS USE SAFETY GLASSES
. Also use face or dust mask if cutting operation is dusty. Everyday
eye glasses only have impact resistant lenses, they are NOT safety glasses.
DO NOT OVER-REACH
. Keep proper footing and balance at all times.
USE THE RECOMMENDED ACCESSORIES.
Consult the manual for recommended accessories. The
use of improper accessories may cause risk of injury.
CHECK DAMAGED PARTS.
Before further use of the machine, a guard or other part that is damaged
should be checked to determine that it will operate properly and perform its intended function. Check for
alignment of moving parts, breakage of parts, mounting, and other conditions that may affect its
operation. A guard or other part that is damaged should be properly repaired or replaced.
NEVER OPERATE A MACHINE WHEN TIRED, OR UNDER THE INFLUENCE OF DRUGS OR
ALCOHOL.
Full mental alertness is required at all times when running a machine.
NEVER ALLOW UNSUPERVISED OR UNTRAINED PERSONNEL TO OPERATE THE MACHINE.
Make sure any instructions you give in regards to machine operation are approved, correct, safe, and
clearly understood.
IF AT ANY TIME YOU ARE EXPERIENCING DIFFICULTIES
performing the intended operation, stop
using the machine! Then contact our service department or ask a qualified expert how the operation
should be performed.
No list of safety guidelines can be complete. Every shop environment is different.
Always consider safety first, as it applies to your individual working conditions. Use this and other
machinery with caution and respect. Failure to follow guidelines could result in serious personal injury,
damage to equipment or poor work results.
Electrical Power:
All electrical power should be removed from the machine before opening the
rear electrical enclosure. It is recommended that the machine have a electrical LOCK-OUT device
installed.
Make sure all electrical equipment has the proper electrical overload protection.
In the event of an electrical short, grounding reduces the risk of electric shock by providing a path of least
resistance to disperse electric current.
Electrocution or a fire can result if the machine is not grounded correctly. Make
sure the ground is connected in accordance with this manual. DO NOT operate the machine if it is not
grounded.
No single list of electrical guidelines can be comprehensive for all shop environments.
Operating this machinery may require additional electrical upgrades specific to your shop environment. It
is your responsibility to make sure your electrical system comply with all local codes and ordinances.
Summary of Contents for SG80AII
