Operator Controls
Rovema VPK Operators Manual
3/2000 VPK REV(B) PANELVIEW 600
5-8
Operator Interface > Operations Screen
BELTS Switch
Use this switch to open or close the film feed belts. When this switch
is set to OPEN, the film feeding belts move away from the forming
tube. When this switch is set to CLOSED, the film feeding belts move
against the forming tube.
You will open the film feeding belts when you want to remove the
forming set or thread film down the forming tube. You will close the
belts when you want to jog the film feeding device or form bags.
HEAT Switch
This switch toggles the power to the horizontal and vertical temperature
controllers on and off. When this switch is set to ENABLED, the
temperature controllers turn on and the horizontal and vertical sealing
devices heat. When this switch is set to DISABLED, the temperature
controllers turn off and the sealing devices begin to cool.
Note:
This switch does not affect the temperature controllers for
optional equipment (i.e. zipper applicators). These devices will
have a separate switch on the touchscreen display.
FEEDER Switch
This switch allows or prevents product drops from the product feeder.
When this switch is set to ENABLED, the product feeder can release
product charges into the bagmaker filling tube during bag forming.
When this switch is set to DISABLED, the product feeder will remain
idle during bag forming.
Note:
This switch should be set to DISABLED during bagmaker setup
to prevent inadvertent product dumps.