12V
battery
Ignition switched
+12V source
Examples
Ignition trigger only. Outputs 1-6 will turn on and off with ignition. Connect
the Red (+) wire to the battery before the black ground.
Page 6 of 8
Configure the Amplink PDM using the App
Back
Output Configuration
OR Triggers
T1
AND Triggers
None
Delay On
00:00
Amp Limit (A)
Name
One
Delay Off
00:00
Test
10
Triggers
Trigger 1
On
Trigger 3
Off
Trigger 2
Off
Voltage (+ve)
Disabled
Disabled
Outputs
Output 1
Output 2
Output 3
Output 4
Output 5
Output 6
Monitor
Setup
Triggers Information
Configure the trigger page
as shown, then proceed to
the Setup page by tapping
Setup on the bottom of
the screen
Monitor
Setup
Triggers Information
On the Setup page tap
each output to open
the configuration page.
In the Configuration page set the
triggers as shown. You can also
set the output name, amp limit and
delay times. When finished tap
the button and proceed to the
next output. Set the triggers as
shown on each output
Back