95
Figure 6.6: Creating a remote scanbox
When creating a remote scanbox you are requested to select a protocol as a first step. The choice
is SMB, FTP and Webdav. Press „Next“ to continue to the scanbox settings shown in Figure 6.6.
The following parameters are available:
Scanbox Name
: A freely selectable name (without special characters). Afterwards, the
scan box can be identified by this name in the scan box configuration and the ROWE
SCAN APP .
Username/Password
: Here, you have to enter the access data to access the shared
directory in the network (Attention: Write protection required!).
Domain
: If the computer on which the shared directory can be found is a member of a
domain, enter this domain here.
Server
Host/IP: The IP address (or host name) of the computer where the shared
directory can be found.
Share:
The name of the shared directory
Subdirectory:
If the directory to be monitored is located in a directory under the shared
directory, enter the path here (in case of several subdirectories separated by "/").
Public access
: Defines whether any user is allowed to use the scan box as scan target
directory in the ROWE SCAN APP or whether access is protected by a user
name/password.
