7.10.3.3 Scan Format
In the field "Scan format", you can determine the dimensions
of the following scan. If you actuate the button as shown in the
adjoining figure, a menu pops up where you can select the
following settings:
Auto
: The format is established automatically using the width
detection feature. In most cases, this setting induces the
requested result.
Figure 7.29: Scan
format
Autoformat
: The format is established automatically by means
of the width detection feature as in case of "Auto" but
afterwards it is extended to the standard format fitting next.
Moreover, the following options are available:
Orientation Portrait/Landscape:
Select whether the
default format is portrait or landscape.
Fixed format On/Off
: If the fixed format is activated
(
On
), the length in feeding direction is considered in
addition to the width when adjusting to the default
format. Otherwise, the width is adapted to the default
format, only
.
The document has to be placed in the center.
If the fixed format is enabled, one part of the
information is cut off if the original is longer than the
fixed format to be adapted on the basis of the
detected width.
Figure 7.30:
Autoformat
Maximum width
: In case of this setting, the maximum
document width is used. Usually, a margin will then still be
visible at the sides which can be cut off manually afterwards.
This option is recommended for damaged originals if the
automatic width detection is not working properly.
Figure 7.31: Auto
(Sensor)
Summary of Contents for Scan 850i
