DLW-1 Phonograph
5-2
21822662
DLW-1 LED’S
POWER SUPPLY BOARD
+9 V LED
Should be on. On when +9 VDC is available at the Power Supply.
+12 V LED
Should be on. On when +12 VDC is available at the Power Supply.
+24 V LED
Should be on. On when +24 VDC is available at the Power Supply.
VALID IR LED (optional)(mounted remotely)
On POWER UP (+9 VDC applied to the ROWELINK CONTROLLER via the POWER SUP-
PLY) this LED flashes 3 times. It also flashes when a VALID IR Remote signal is seen.
ROWELINK CONTROLLER
5 VDC,12 VDC, 24 VDC, and 24VAC LED’s
Should be on. On when there is power to the ROWELINK CONTROLLER via the HUB.
IR RCV LED
Flashes whenever any IR signal is seen by the IR RCVR (optional). May flash due to ambient light.
KID RL TX LED
Should be flashing **. Flashes when the ROWELINK CONTROLLER sends an RL signal back to
CORE COMPUTER. Rate is approximately ten times per second.
CC RL RX LED
Should be flashing**. Flashes when ROWELINK CONTROLLER receives a RL signal from one of
the ROWELINK devices. Appears almost continuously on (rate is more than 20 times per second).
CC RL TX LED
Should be flashing **. Flashes when Rowelink Master Commands are sent from the Computer Core.
Appears almost continuously on (rate is more than 20 times per second).
CRDT RL TX LED
Should be flashing **. Flashes when the ROWELINK CONTROLLER sends a RL signal back to
the CORE COMPUTER. Rate is approximately once per second.
CRDT STATUS LED
Will flash when a coin is inserted and the CRDT RL TX LED is flashing. May or may not flash when
coin is inserted if the CRDT RL TX LED is not flashing.
AV CONTROLLER (STUDIO SOUND ONLY)
POWER LED
Should be on. On when all 4 voltages are present (+5 V, +8.5 V, +15 V, -15 V).
STATUS LED
On Power Up (Power applied to the AV Controller) this LED flashes 3 times.
ROWELINK LED
Should be flashing **. Flashes when the AV Controller sends a RL signal back to the ROWELINK
CONTROLLER. Rate is approximately twice per second.
Summary of Contents for StarLink DLW-1
