4
EN
Select the fabric to be ironed on the thermostat dial. For perfect results, an optimum
position for each fabric has been pre-defined. This position is marked on the dial and
also represented with a louder “click” sound. You can also set your iron based on
the international temperature measurements •, ••, •••. Ensure your thermostat dial is
positioned on these settings.
When your iron reaches the required temperature, the thermostat indicator turns off
fig.7
. You can start ironing.
IMPORTANT The iron takes longer to cool down than to heat up. We recommend that you start
with fabrics to be ironed at a low temperature. For mixed fabrics set the temperature for the
most delicate fabric.
TIP Always spray starch onto the reverse side of the fabric to be ironed.
3 • Dry ironing
Set the temperature to suit the type of material without pushing the autosteam
trigger and shot of steam button.
4 • Steam ironing
(Autosteam & Steamforce)
Your iron is equipped with the Autosteam function*. The steam quantity and the
temperature will adjust automatically to the selected fabric. To get continuous
steam squeeze the autosteam trigger
fig.8
.
Your iron is equipped with a pump called Steamforce Technology which pushes
30 % more steam into the heart of the fibres. The pump may cause a slight noise. This
is not a technical fault! A few seconds are necessary to produce or to stop the steam.
5 • Shot of steam
Press the shot of steam button to generate a powerful jet of steam
fig.9
.
IMPORTANT Leave an interval of a few seconds between each shot and wait until the flow of
steam has finished before standing the iron on its heel.
6 • Vertical shot of steam
(from temperature setting (••) upwards)
Hold the iron vertically and press the shot of steam button to remove creases from
suits, jackets, skirts, hanging curtains etc.
fig.10
.
IMPORTANT Never direct the steam at persons or animals!
TIP Hold the iron 10 to 20 centimetres away from the garment to avoid burning delicate
fabrics.
7 • Spray
Press the spray button to dampen difficult creases
fig.11
.
8 • Anti-Drip system
It prevents water escaping from the soleplate when the temperature is too low.
9 • Auto Off function*
• For your safety, the electronic system cuts off the power and the auto off indicator
light flashes
fig.12a-12b
when:
- The iron remains motionless for more than 8 minutes on its heel.
FABRIC
THERMOSTAT
LED
INDICATION
IRONING
LABEL
Nylon (Synthetic
fibres, e.g. viscose,
polyester)
NYLON
silk
SILK
wool
WOOL
cotton
COTTON
linen
LINEN
LINEN
COTTON
WOOL
SILK
NYLON
AUTO OFF
(*) Depending on model
1103910063 DW9000 D1_110x220mm 16/04/13 16:54 Page4
Summary of Contents for DW9000
