3 • Switching on your steam
generator
Press on the on / off switch
- fig.4
, it
begins flashing. The green light (located
on the control panel) flashes and the
boiler heats up.
When starting, and regularly while it is
being used, your steam generator's
electric pump injects water into the boiler.
It makes a noise but this is quite normal.
The steam generator and the iron are
ready for use when the steam indicator
light is on and the iron light goes out.
4 • Operating the control panel
• Flashing green light
- fig.6
: the water is
heating up in the boiler.
• Continuous green light
- fig.7
: steam is
ready for use.
• Continuous red light
- fig.11
: the water
tank is empty.
•
The “Calc-Away System” orange
indicator flashes
- fig. 13
: the collector
needs to be rinsed.
5 • Using your steam generator
Place the iron’s temperature control
-
fig.5
to the type of fabric to be ironed and
set the steam output
- fig.6
- see table
below. The iron temperature control light
turns on.
While ironing, the light on top of the iron
and the steam ready light turn on and
off, as the temperature adjusts without
interrupting ironing. To obtain steam,
press on the steam control button
beneath the iron handle and keep it
pressed
- fig.8
. The steam will stop when
you release the button.
Always spray starch on the reverse side
of the fabric to be ironed.
The first time the appliance is used,
there may be some fumes and smell but
this is not harmful. They will not affect
use and will disappear quickly.
USE
T
YPE OF
FABRIC
S
ETTING
TEMPERATURE CONTROL
S
ETTING STEAM
CONTROL
C
OTTON
/
L
INEN
• • •
S
ILK
/ W
OOL
• •
S
YNTHETICS
(Polyester, Acetate,
Acrylic, Polyamide)
•
Recommendations: To prime the
steam circuit, either before using the
iron for the first time, or if you have
not used the steam function for a few
minutes, press the steam control
button several times in a row
- fig.8
,
holding the iron away from your
clothes. This will enable any cold
water to be removed from the steam
circuit.
Iron temperature control setting: Start
with fabrics to be ironed at a low
temperature and finish with those
which need higher temperatures. Each
time you change fabrics, wait for the
light to turn off. Mixed fibre fabrics:
set the ironing temperature to the
setting for the most delicate fabric.
Woollen garments: press repeatedly
on the steam control button to obtain
short bursts of steam, without placing
the iron on the garment itself. This will
avoid making the fabric shiny. Steam
output control dial setting: Thick
fabric: increase the steam setting. At a
low temperature: set the steam output
control dial to the low position. For
delicate fabrics(•), press the steam
control button (under the handle of
the iron) intermittently to avoid
possible water droplets appearing
with the steam.
4
FerPRO_1800113725:FerClassic_PRO_110x154mm 28/11/08 12:39 Page 4
