36/48
No. Designation
1
Heating heads (3)
2
Upper tube section
3
Decorative cone
4
ON/OFF switch with pilot lamps
5
Middle tube section
6
Lower tube section
7 Base
Tab. 2: Appliance labelling
3.2
Starting use
The appliance can be put into operation after removing the packaging. Proceed as follows
for this:
1. Make sure that the appliance is switched off. Then connect the quartz patio heater to an
earthed socket protected with an earth-leakage circuit breaker.
2. Now switch on the appliance by pressing the ON/OFF switches (see Fig. 4, No. 4). The
red pilot lamps light up. Each heating head has a heat output of 650 W.
Fig.5 : ON/OFF switch
The following applies here:
= Low heat output (650 W)
= Medium heat output (1350 W)
= Maximum heat output (2000 W)
GB
