31/40
3. Operating Instructions
3.1 Appliance overview
Fig. 2: Appliance overview
No. Designation
1
Pilot lamp
2
Temperature control
3
Heating level switch
Tab. 2: Appliance labeling
3.2
Starting use
After all parts are assembled (see section 2.3), the appliance can be put into operation.
Proceed as follows for this:
1. Make sure the heating level switch (see Fig. 2, No. 3) is at position "0" and the pilot
lamp (see Fig. 2, No. 1) is not lit. Then connect the thermal wave heater to an earthed
socket protected with an earth-leakage circuit breaker.
2. Now switch on the appliance by turning the heating level switch (see Fig. 2, No. 3) to
the desired heat output. The following options are available for selection.
1
2
3
GB
