5. Wall panels
Position a plain wall panel and a window panel on the floor as shown in the first diagram. Note how the panel frames sit on the floor with the panel cladding overhanging the
floor edge. Ensure square and secure using 4 x 63mm screws, screw through the frame of the window panel into the frame of the plain panel. Align the back panel next to
the plain panel and secure in the same way using 4 x 63mm screws. Continue to add the rest of the panels in the same way.
6. Door handle & tower bolts
Push the door lock into the rebate on the edge of the right-hand door as shown and secure using 2 x 25mm brass screws. To fit the metal door handle, it first maybe necessary
to cut the spindle bar down to 88mm. Push the spindle bar through the door latch mechanism. Fit a door handle to the metal spindle bar on each side of the door and secure
them in place using 4 x 25mm black countersunk screws per handle. On the other door fit the lock plate using 2 x 25mm brass screws. Attach the tower bolts to the inside
of the left door as shown using 4 x 19mm round head screws per bolt. Mark where the tower bolts touch the top and bottom door frame and drill a 12mm diameter hole
for each bolt.
It is recommended to drill pilot holes with a 3mm drill
bit for all screws in this section.
Panel cladding
overhangs floor edge
Panel frames rest
on the floor
Important
When attaching the door panel
ensure that the screws are
screwed though the window
panel into the door panel.
Lock catch
plate
Drill
Mark where the tower bolts touch the
top and bottom door frame and drill a
12mm diameter hole for each bolt.
12mm
Spindle may need to
be cut to 88mm
Drill
3mm
Door panel
Window panel
Window panel
Window panel
Window panel
63mm
63mm
19mm
25mm
Black
25mm
Brass
25mm
Brass
