9. Roof panels
Lift a large roof panel onto the back of the building and a small roof panel on next to it. Ensure they are resting evenly next to each other and secure together through the
panel frames using 2 x 63mm screws. So that adjustments can be made do not fully tighten these screws until all roof panels are in place. Have a second person holding the
panels up while working round the roof adding the remaining panels. With all the roof panels in position and adjusted as necessary, fully tighten the screws. Attach the roof
panels to the walls using 2 x 63mm screws per panel, screw though the roof panel frame into the top frame of the wall panel.
It is recommended to drill pilot holes with a
3mm drill bit for all screws in this section.
Drill
3mm
7. Walls to floor
With all the wall panels in position, check they are all sitting square on the floor and secure to the floor using 1 x 63mm screws for each small panel and 2 x 63mm screws
for the larger back and door panels, screw through the wall panel frame and into the floor.
8. Window coverstrips
To each window panel attach two window coverstrip. On the inside, position the strip as shown and secure to the panel frame using 2 x 50mm screws per strip.
Panel frame
Floor
63mm
63mm
63mm
63mm
50mm