30mm
30mm
30mm
8. Coverstrips, bargeboards and finials
Fit a coverstrip into each corner, attach using 3 x 30mm nails per strip. Attach bargeboards at the front so that the top edge is flush with the roof line and the two boards
meet evenly at the apex. Secure using 3 x 30mm nails per board. Over the join of the two bargeboards attach a finial using 2 x 30mm nails. Repeat for the bargeboards and
finial at the back of the building.
9. Fitting the door
Place the door into position. Fix the three T-hinges to the door with 4 x 25mm screws per hinge. Secure the hinges to the door frame using 3 x 25mm screws per hinge.
Fit the turn button to the door frame using 1 x 25mm screw and then fit the hasp and staple with 7 x 19mm round head screws, see the diagram for the position of these.
25mm
25mm
19mm
View from outside of building
30mm
2018 © Rowlinson Garden Products Ltd
We constantly improve the quality of our products,
occasionally the components may differ from the
components shown and are only correct at time of
printing. We reserve the right to change the
specification of our products without prior notice.
If in doubt of any aspect regarding the assembly, use or safety of your garden shed please contact us :
Help Line: (Normal Office Hours) 01829 261 121
Email: support@rowgar.co.uk
ROWLINSON GARDEN PRODUCTS LIMITED
Green Lane
Wardle Nr. Nantwich
Cheshire
CW5 6BN
www.rowgar.co.uk
Important information
Shiplap buildings come ready stained but this is only a preparatory treatment. To
VALIDATE
the guarantee, the building must be properly treated with a recognised
external wood preserver
WITHIN 3 MONTHS
of assembly and
RE-TREATED ANNUALLY
thereafter. Adequate provision must be made to ensure ground contact
is avoided and air is able to circulate underneath the building.
Placing the building on a concrete pad or slab base is acceptable provided that the building is not allowed to sit in pooled water during wet conditions.
If the building is to sit on soil or grass it
MUST
be erected on pressure treated wooden 50mm x 50mm or similar bearers
(These are not supplied in the kit).
Rowlinson Garden Products recommend using pressure treated bearers with all buildings on any type of base.
Timber Information.
As timber is a natural material, there are certain weather conditions that may affect the materials properties. In times of excessive dry spells the material may lose some
of its internal moisture causing a certain degree of shrinkage on a panel and in periods of excessive rain there will be a certain amount of swelling throughout the wooden
panels. This process can not be avoided. If you have problems with certain boards shrinking in dry spells try to decrease the amount of direct sunlight on the building or
the amount of air passing over the building. During hot spells spray water directly onto the panels with the aid of a garden hose.
