10mm
Felt
nails
10mm
Felt
nails
45mm
10mm
Felt
nails
10mm
Felt
nails
10mm
Felt
nails
11. Bargeboards and finials
At the front and rear of the building attach two bargeboards. Have the top edges flush with the roof line and the two boards meeting in the middle at the apex of the roof
secure using 3 x 40mm nails per board. Fit a finial centrally over the join between the bargeboards use 2 x 40mm nails per finial.
40mm
40mm
40mm
45mm
Upper edge
Lower edge
10. Roofing felt
Cut the 6m roofing felt roll into two equal lengths. Place a length over half of the roof. At the front and along the lower edge of the roof leave an overhang of felt of at least
45mm. Fold down the felt along the lower edge and secure to the felt batten using 30 x 10mm felt nails evenly spaced. Tension the felt over the roof and secure along the
upper edge using 8 x 10mm felt nails. Repeat this for the second piece of felt on the other half of the roof. Once the two pieces of felt are in place take the 3m ridge felt roll
and place over the apex of the roof making sure it sits centrally over the roof ridge and overlaps the other two felt pieces, attach using 30 x 10mm felt nails evenly spaced,
along the two long edges of the ridge felt. Dress down the ends of the felt and at the front and back of the building attach to the roof panel framing with 8 x 10mm felt nails.
Once secured trim off any excess felt.
12. Coverstrips
Fit a Coverstrips into each corner of the wall panels, attach using 3 x 40mm nails per strip. The remaining three coverstrips are used to cover the panel joins, one on each
side and one on the back, attach using 3 x 40mm nails per strip.
40mm
40mm
40mm
40mm
40mm
40mm
40mm
