3. Front and rear connecting bars
4. Lower legs and finials
Join the front of the three track assemblies using the
front connecting bars, push the bars in to the sockets
of the legs as shown. secure by ensuring the push
button mechanism in the legs properly locates into
the hole of the connecting bar.
Please note:
Failure to ensure the button mechanism is
locking the components together will result in
the canopy being unsafe.
Join the rear of the three track assemblies using the
rear connecting bars, push the bars in to the sockets
of the track sections as shown. Secure in place using
1 x 10mm bolt at each end.
Position the curl finial on top of the leg. Put the
plastic spacer over the screw thread of the ball
finial. Screw the ball finial through the hole in
the curl finial into the hole in the top of the leg.
Connect the lower leg to the upper leg, ensure the
push button mechanism on the lower leg is
properly located in the hole of the upper leg.
On the bottom of each lower leg insert a foot
plate. Align the holes of the lower leg and foot
plate and secure together using 1 x 60mm bolt and
nut per foot.
Please note:
The two holes in the post of the foot plate are
to adjust the height of the canopy. Ensure the
same height hole is use on all three legs
.
Plastic spacer
60mm
Height adjust
holes.
10mm
10mm
10mm
