9
English
Installation instructions for R frame
See illustrations on page 2.
Installation instructions for RS seal
See illustrations on page 3.
Lubricate the frame sparsely on the outside
and thoroughly on the inside with Roxtec Lub-
ricant, especially into the corners. Remove
any dirt and insert the frame into the sleeve/
hole. Push the front fittings to the sides.
Cut or bend the net with a knife or your fing-
ers to enable cables/pipes to pass through.
Adapt modules to cables or pipes by peeling
off layers.
Achieve a 0.1-1.0 mm gap between the
halves when held against the cable/pipe.
Lubricate all modules thoroughly, both the
inside and the outside surfaces.
Insert modules and cables/pipes according to
your installation plan.
Push the front fittings back towards the
centre.
Tighten the nuts crosswise. The frame will
compress until it is sealed. For detailed infor-
mation, see page 52 and 54.
Note
Wait 24 hours or longer after installation
before exposing the cables/pipes to strain or
pressure.
Cables shall go straight through the frame.
1
2
3A
3B
3C
4
5
6
1
2
3
4
5
6
Remove any dirt in the sleeve/hole and pull
the cable/pipe through.
Adapt the seal to the cable/pipe by peeling
off layers from the halves.
Achieve a 0-1.0 mm gap between the halves
when held against the cable/pipe.
Lubricate thoroughly on the inside surfaces
and sparsely on the outside of the seal with
Roxtec Lubricant.
Insert the halves in the sleeve/hole.
Tighten the screws crosswise. The seal will
compress and seal the transit. For detailed
information, see page 53 and 54.
