10
11
Rev. 14.03.2017
Rev. 14.03.2017
9.
Prevent damages to the power cable by avoiding squeezing or bending it or rubbing it on sharp
edges. Also keep the power cable away from hot surfaces and open flames.
10. ATTENTION! DANGER TO LIFE! While cleaning, never immerse the device in water or other liquids.
11. Under no circumstances open the housing.
12. The drinks that are warmed up by the device can get very hot. Take appropriate precautions.
13. Clean the device regularly so that dirt cannot settle permanently.
TECHNICAL DATA
Product name
Water boiler
Model
RCWK 10A RCWK 16A RCWK 20A RCWK 26A RCWK 30A
Rated voltage [V] / Frequency
[Hz]
230~V±10% / 50Hz
Rated power [W]
1600
2200
2200
2500
2500
Heating temperature (°C)
55-100
55-100
55-100
55-100
55-100
Tank’s capacity (up to the
maximum level)(l)
10
16
20
24,5
26
Total tank’s capacity (l)
11,5
17,4
21,4
27,1
30
Weight (kg)
2,7
3,75
3,6
3,95
4,5
SCOPE OF APPLICATION
The boiler is designed for water boiling and heating as well as for preparing alcoholic beverages (eg. Mulled
wine / beer).
Do not use the device to:
- cook soups or other drinks;
- warm or heat flammable, noxious, particularly volatile, or any other toxic substances.
WARNING: Pay special attention to the foam production during the preparation of mulled beer – beer
level in the tank should be controlled (the tank should not be fully filled with beer).
The user is liable for any damage resulting from non-intended use of the device!
BEFORE FIRST USE
Upon receipt of the goods, check the packaging for integrity and open it. If the packaging is damaged, please
contact your transport company and distributor within 3 days, and document the damages as detailed as
possible. Do not turn the package upside down! When transporting the package, please ensure that it is kept
horizontal and stable.
DISPOSING OF PACKAGING
Please keep all packaging materials (cardboard, plastic tapes and Styrofoam), so that in case of a problem, the
device can be sent back to the service centre in accurate condition
INSTALLING THE APPLIANCE
The temperature of environment should not exceed 45 °C and the relative humidity should be less than
85%. Ensure good ventilation in the room in which the device is used. The distance between the back of the
water boiler and the wall should be at least 20 cm, minimum distance between the sides of the device and
the walls should be at least 10 cm on each side and 35 cm between the top of the device and the ceiling.
Keep the device away from hot surfaces. Operate the device on flat, stable, clean, refractory and dry surfaces
out of the reach of children and people with mental disabilities. Install the device making sure that constant
access to the main plug is ensured. The power cable connected to the device must be properly grounded and
should correspond to the technical details. Before the first use, remove all elements and clean them along
with the entire device.
1.
lid
2.
lid handle
3.
water tank handle
4.
water tank
5.
power cord
6.
“KEEP WARM” indicator (water is kept warm at the present temperature)
7.
“BOIL” indicator (water is being heated)
8.
device base and reset button:
PRINCIPLE OF OPERATION
9. thermostat knob – temperature setting
1
55°C
2
65°C
3
80°C
4
90°C
5
100°C
HIGH
100°C
10. base with drip tray
11. drain tap
Before switching the device to the power supply, make sure that the thermostat knob is switched off, this
means, in the “OFF” position. Make sure that the drain tap is closed (it should be at the maximum on the
right or left side). Fill the tank with water. Make sure that the maximum water level in the tank stays at or
below the “MAX” mark, which can be found on the inner wall of the tank. Cover the tank with the lid and
turn the lid clockwise until it is closed. Then insert the power cord into power outlet and set the thermostat
as desired.
1
2
3
4
5
6
7
8
9
10
11
