5
C603R 010909
Wire cable fixing should be used with stone or marble panel which could fracture
if drilled. (See Fig 3)
Option 3 Wire cable fixing (I)
Fix two `screw eyes’ to the rear of the opening. (Note the minimum and maximum
height restrictions in the diagram above). Thread the wire cable through the top hole
located on the side of the fire trim frame. Thread through the `screw eye’ and then
through the bottom hole located on the side of the trim frame.
(Repeat for opposite side).
Pull the wire cable and carefully push the firebox into a central position in the
opening. Thread each end of the wire cable through the retaining bush. Adjust the
cable and tighten the retaining bush to ensure that a good seal is made between the
firebox and back panel.
Retaining
Bush
Screw eye
Min Height
300mm
Max Height
330mm
420mm apart
Two `screw eyes’ are fixed
to the rear of the opening
with wall plugs.
Min height from base of
opening–300mm
Max height from base of
opening–330mm
`Screw eyes’ to be 420mm
apart
Cable fixing holes
Fig. 3
