It is recommended that the appliance is serviced annually by a competent person and that the flue is checked for
satisfactory clearance of products and that there is no excessive build up of soot.
The curing effect of heating the coals will cause an initial odour which, although not harmful, may require
additional ventilation until the odour has disappeared.
This appliance will run on Full for approximately 4.4 hours on one therm of gas.
Clearance to Shelves
Minimum clearances to underside of a 150mm (6ins) combustible shelf from the top of the fire opening must be
228mm (9ins). Add 12.5mm (1/2in) to this clearance for every 25mm (1in) increased depth of shelf.
Clearance to Side
Minimum clearance required to any combustible material to the side of the appliance must be 150mm (6ins).
TO LIGHT THE APPLIANCE
1.
Remove the fret from the fire front to gain access to the gas control and igniter.
2.
Press and turn the gas control knob anti-clockwise until the indicator is opposite the IGN. Keep the gas control
fully depressed.
3.
Press and release the ignition button and check that the pilot flame situated on the right hand side of the burner
has lit at both ports. Keep the gas control depressed for a further 20 seconds.
4.
Release the gas control and check the pilot flame remains lit.
5.
Push in the gas control slightly and turn anti-clockwise so that the indicator dot is at the required setting.
Replace the fret.
6.
To turn off the appliance and pilot: Push in slightly, turn the gas control knob clockwise from any position -
until the indicator dot is opposite OFF.
IMPORTANT: After turning OFF, or if the pilot and appliance go out for any other reason, wait for 3 minutes
before attempting to relight.
If required the pilot may be lit by a long taper or spill placed down the left-hand side of the front bottom coal.
Page 3
