GB
5
CONNECTING THE GAS CYLINDER
This appliance is only suitable for use with low-pressure butane or propane gas and ftted with the appropriate low-
pressure regulator via a fexible hose. The hose should be secured to the regulator and the appliance with hose clips.
Please consult your LPG dealer for information regarding a suitable regulator for the gas cylinder.
TO CHECK FOR LEAKS
1. Make 2-3 fuid ounces of leak detecting solution by mixing one part washing up liquid with 3 parts water.
2. Ensure the control valve is “OFF”.
3. Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the connections are secure then
turn ON the gas.
4. Brush the soapy solution on to the hose and all joints. If bubbles appear you have a leak, which must be rectifed
before use.
5. Retest after fxing the fault. Turn off the gas at the cylinder after testing.
6. If detected leakage can not be rectifed, do not attempt to cure leakage but consult your gas dealer.
.
REGULATOR AND HOSE
-Use only regulators and hose approved for LPG at the above pressures. The life expectancy of the regulator is
estimated as 10 years. It is recommended that the regulator is changed within 10 years of the date of manufacture.
-The use of the wrong regulator or hose is unsafe, always check that you have the correct items before operating
-
the barbecue.
-The hose used must conform to the relevant standard for the country of use. The length of the hose must be
1.5 meters (maximum). Worn or damaged hose must be replaced. Ensure that the hose is not obstructed, kinked,
or in contact with any part of the barbecue other than at its connection.
-The hose should not be twisted or kinked when attached to the gas cylinder.
-No part of the hose should touch any part of the appliance. So site the cylinder out to the left hand side of the
appliance at the maximum distant permitted by the hose length.
Storage of an appliance indoors is only permissible if the cylinder is disconnected and removed from the appliance.
When the appliance is not to be used for a period of time it should be stored in its original packaging and stored in
a dry dust free environment.
-The appliance must be used with 1 LB gas cylinder.
-The gas cylinder should not be dropped or handled roughly! If the appliance is not in use, the cylinder must be
-
disconnected. Replace the protective cap on the cylinder after disconnecting the cylinder from the appliance.
-Cylinders must be stored outdoors in an upright position and out of the reach of children.
-Do not store the cylinder near fames, pilot lights or other sources of ignition.
BEFORE USE PLEASE CHECK FOR LEAKS
Never check for leaks with a naked flame, always use a soapy water solution
STORAGE OF THE APPLIANCE
GAS CYLINDER
-The cylinder must never be stored where temperatures can reach over 50°C.
-DO NOT SMOKE. The cylinder should be changed away from any source of ignition.
