Diagram of massage tub
Installation method
Installation steps
This product adopts standard parts, so please refer to product water and electrical diagrams and electrical
parameter plate when installation.
1. Decide product installation position
Place the tub at the installation area, adjust the bottom nuts for leveling. (See the diagrams below).
2. Connect sewage pipeline
Insert the 1 1/2"plastic pipe into the sewage pipeline, then seal with tape or glass adhesive. Do not fold the pipe, so as not to
influence draining effect. (See the diagrams below).
Wall drain type connection diagram
Floor drain type connection diagram
3. Connecting cold water pipe and hot water pipe
The cold water pipe and hot water pipe are high-pressure reticulated pipes. Please follow the connector indication in
connection. (Note: One valve for cold water pipe and one valve for hot water pipe must be installed.)
4. Power connection
Securely connect the power cables to the all-pole
disconnection RCD, and pay attention to waterproofing.
User must securely connect the yellow and green ground
wire (equipotential wire) with the ground wire of the house.
5. Checking, cleaning and testing
After completing all above steps, please clean the tub, open
the drainer, and use clean water for washing. Then check
for normal operation of all functions, then fill the tub with
water and make sure there is no water leakage in all
pipelines.
3
Main devices
①
Massage Jet
⑦
Water Force Adjustment:
②
Function Changer Switch
⑧
Water Suction Device
③
Cold Water Control
⑨
Pillow
④
Hot Water Control
⑩
Drainer
⑤
Multifunctional Shower Head
⑪
Draining switch
⑥
Air Switch
⑫
Waterfall
A
djustment nut
Stainless steel rack
Equipotential terminal
Yellow and green ground
wire (equipotential wire)