2
Installation
：
Useful instruction for transport
In order to prevent oil contamination in the hermetic compressor from flowing into the coolin
g
circuit, it
is necessary to always carry, store and handle the machine in a vertical position, following the
instructions found on the packaging.
Unpacking:
I
f the machine has not been damaged remove the plastic film from all the stainless-steel panels
.
Important:
The various packaging should be kept away from children since this is potentially dangerous.
Dispose of packaging according to the regulations from local authorities.
Loading:
1.
When loading the unit, make sure front and rear vents inside the unit are left open and are not
covered or blocked with drinks, trays, plates, or any other objects. The unit relies on airflow to
ensure all shelves remain cold. By blocking the air vents, even partially, the air flow is restricted,
and upper shelves will not reach the required temperature
.
2.
Do not fill the unit with room temperature product (warm drinks) unless you intend leaving the
doors closed for a few hours to enable it to cool the drinks and recover temperature.
Positioning:
1.
Do not install the machine in the area where it can be damaged by water
.
2.
This unit is intended for indoor use only
.
3.
Place machine on a horizontal and sturdy surface
.
4.
For good ventilation, keep a distance of 200mm between unit and wall or other objects. Increase
the distance if the objects are a near a heating source. When the display is in place, press
the brake on the wheels to keep it level and secure
.
Assembling
1.
Remove the bottom pallet from the machine
.
2.
Put glass shelves on to the shelf support
.
3.
The unit has factory set temperature and does not need to be changed.
Electrical connection
Before inserting the plug in to the electrical socket, carefully read the following precautions:
1.
Make sure that the machines properly connected to an efficient grounding system, in
compliance with current safety standards
.
2.
Make sure that the voltage is in accordance with what indicated on the "serial number C
label
applied on the chassis
.
