RSL-382CR / 2702CR / 1062CR
9
1. Follow the steps in the "Loading Film" procedure by loading the upper shaft with
pressure sensitive film, e.g. (Royal Print-Pro Film) and lower shaft with pressure
sensitive mounting adhesive films or backing paper (Royal Sovereign White-Mount or
Clear-Mount).
2. Pull the upper laminate under the upper idle bar and separate the release liner from
the laminate.
3. Tape the release liner to the Take-Up Paper Core and allow the laminate to hang over
the main rollers.
4. Pull up the mounting adhesive and tack it to the laminate hanging over the rollers
(do not use the Lower Idle Bar).
5. Reinstall the Front Table, and close the Safety Cover.
6. Adjust the nip setting to 1/4"(6mm).
7. Insert and push the leader board until board reaches the nip point.
8. Press the Run button and adjust the supply roll tension knobs by rotating clockwise or
counterclockwise. Turn it until the supply roll films have some resistance (the tension
varies depending on the thickness of a film; the thicker the film the more tension is
required).
9. Press Stop button when the leader board has completely exited the rear of the unit.
11. Use the Cross Cutter to cut the leader board from the web (see page18).
12. Set the roller nip setting to the appropriate position for the lamination application.
UBLF!VQ!EFWJDF
QBQFS!CBDL
MBNJ.SPMMFS
CBDLJOH!QBQFS
CBTF!GJMN
MPXFS!JEMF!CBS
MPXFS!JEMF!CBS
)493NB02223NB*
VQQFS!JEMF!CBS
DPME!GJMN
SFXJOEFS
QVMM.SPMMFS
6.2. COLD FILM
