8
THREADING FILM
Hot Film-Double Laminating
Caution:
Hot Shoes and Heat Plates are extremely hot. Be careful not to touch the hot shoes or heat plates while
threading the film.
1. Turn the power switch on(“I” position).(The power switch is located on the right-hand side of the unit)
2. Push "TEMP." button to select appropriate temperature mode.
3. Complete the steps in the “Loading Film” section.
4. Remove the Front Feed Table.
5. Pull down the upper film over the Safety cover to the lower film; align and center the lower film to the upper film and
tighten the core screws.
6. Rewind the upper film until it aligns with the safety cover.
7. Take the safety cover off.
8. Then thread the lower film over the lower idle Bar until the film rests on the upper Heat shoe.(Before threading film,
Confirm the lower idle bar is in the location showing in the picture 1)
9. Push the idle bar up to the place showing in the picture 2. Then Put the Front Table back on.
10. Push "RUN/STOP" button to start rollers and thread the film using the laminating Threading Card(picture 3).
11. Put the safety cover back on.
Picture 1
Picture 2
Picture 3
Upper Roll Film
Lower Roll Film
Idle Bar
Idle Bar
Laminating Roller
Pull Roller
Adhesive Side
Glossy side
Glossy Side
Adhesive Side
Heat Plate
Heat Shoe-low
Heat Shoe-up
