RSL-2702S
9
1. Turn the power switch on("I" position). Power switch is located in the rear of the unit
on the left side.
2. Follow the steps in the "Loading Film" procedure by loading the upper shaft with OPP
Film.
Note: OPP film is recommended for single - sided hot lamination
3. Set the temperature and speed as: Temperature
(Upper roller: 110-130°C; Lower roller: 20°C) and Speed 3-5.
4. Center the OPP film.
5. Thread the film under the Upper Idle Bar and underneath the Safety Cover until the
film rests on the upper hot roller .
6. Pull a sheet of 11" x 17" or larger size paper into the laminating roller and pass under
the idle-bar and over the shaft-decurling bar. Make sure the idle-bar being in the lower
location while laminating.
7. Link the paper to the film.
8. Adjust the nip setting to "Laminating" mode.
9. Press the run button and adjust the supply roll film tension knob by turning clockwise
or counterclockwise. Turn it until the supply roll film has some resistance(The tension
varies depending on the film type and thickness. Thicker films usually require more
tension (Picture 6, on page 7).
10. Stop the laminator when all of the laminated items have completely exited the rear of
the machine.
6.3. hOT FILm SINGLE - SIDED LAmINATING
LAMINATING
HOT ROLLERS
IDLE BAR
IDLE BAR
SHAFT-DECURLING BAR
PULL ROLLERS
OPP FILM
