15
Cleaning the Body of the laminator
To clean the machine body, dampen a cloth with water only and gently wipe the
machine clean.
Removing Adhesive Build Up
1. Remove the film from the laminator.
2. Use a damp (water only) cloth and a rubber gum eraser to remove
the adhesive on the Teflon (metal) and silicone rollers.
NOTE: Rub firmly but do not scrub the rollers vigorously as this may
scratch the surface. Do not use sharp metal objects, steel wool,
or abrasive, as these may also damage the rollers.
11. MAINTENANCE
10. USING CROSS CUTTER
1. After lamination, move the cutter approximately to the center of the completed
application at the desired point of detachment (Figure 1).
2. Grasp film with one hand, press the cutter downward into the application and slide
it first to one end of the application, then to the other end to complete the cut
(Figure 2 & 3).
Figure 1
Figure 2
Figure 3
The cross cutter is located on the rear exit table of the machine.
