8
6.3. MOUNTING
Figure 1
1. Lay the decaled image face down on a flat surface.
Carefully peel back and put a crease along the edge of the
release liner (Approximately 1 inch or 25mm, Figure 1).
2. With the image facing up, align the image onto the board.
Press firmly from the center out (Figure 2).
3. Adjust the pressure lever to ensure the proper opening
(Figure 3).
4. Flip the image over the upper roller and hold on to the
release liner (Figure 4).
5. Press the Run Button , and then press the Stop Button
while the board has being completely exited from the rear
of the unit. Trim the board if necessary.(Figure 5).
Figure 2
Figure 3
Figure 4
Figure 5
RSL-382S/2702S
