Royal 11031 Assembly And Operating Instructions Manual Download

Page: 27 / 64

Caution:

The blade begins to rotate as soon as

the engine is started.

Important:

Before you start the engine, move the motor
brake several times to be sure that the stop
cable is properly working.

Note:

The engine is

factory set to a speed that is optimal for cutting
and blowing grass into the basket and is
designed to provide many years of use.

5. Check the oil level.
6. Fill the tank with approx. 1.9 liters of petrol

whenever empty, using a funnel and measuring
jug to do so. Ensure that the petrol is free of any
contaminants.

Warning:

Never use more than one safety petrol

can. Do not smoke when refueling. Switch off the
engine before refueling and allow the engine to cool
down for a few minutes.
7. Ensure that the ignition cable is connected to the

spark plug.

Move the speed lever to position

“I

I”

9. Stand behind the mower. Place one hand on the

engine start/stop lever. Place the other hand on
the starter handle.

10.

Start the engine using the reversing starter (Fig.
1/Item 4). To do this pull the handle approx. 10 –
15 cm (until you feel a resistance) and then start
the engine with a sharp pull. If the engine does
not start, pull the handle again.

Important!

Never allow the starter cord to snap

back.

Note:

In cold weather, it may be necessary to

repeat the starting process several times.

11.

When the engine is at working temperature it can
be started in the “Tortoise” (Fig. 7) setting.

Important:

Attempting to start the engine when

set at position

“I

I”

may cause the spark plug to

become wet if the engine is at working
temperature. Wait a few minutes before
attempting to start the engine again.

Mulching

In the mulching mode the cuttings are shredded in
the enclosed mower housing and then spread back
onto the lawn. It is not necessary to gather and
dispose of the grass.

Important:

Mulching is only possible if the lawn is

relatively short. Optimum results can be achieved
only with a mulching blade (available as an
accessory).

To use the mulching function, disconnect the debris
bag, slide the mulching adaptor into the ejector
opening (Fig. 6a/Item 22) and close the ejector
opening.

Side ejector

You should fit the mulching adaptor (Item 22) in
order to use the side ejector. Connect the side
ejector adaptor (Fig. 6b/Item 21) as shown in Figure
6b.

6.1 Before mowing

Important information

1. Make sure that you are properly dressed when

mowing. Wear sturdy, non-slip footwear; do not
wear sandals or tennis shoes.

2. Inspect the blade. A blade that is bent or

damaged in any other way must be immediately
exchanged for a genuine Einhell replacement
blade.

3. Do not fill the fuel tank indoors, but rather out in

the open. Use a filling funnel and a measuring
jug. Wipe off any spilled petrol.

4. Read and follow in the instructions in the

operating manual as well as the information
regarding the engine and accessory equipment.
Store the manual in a place where it can be
readily accessed by other users of the machine.

5. Exhaust gas is dangerous. Only start the engine

out in the open.

6. Make sure that all the guards are fitted and that

they are in good working order.

7. The machine should only be operated by

persons who are well informed with the way it
works, and who are in reasonably good physical
condition.

8. It can be dangerous to mow the grass when it is

wet. Try to ensure that you only mow the grass
when it is dry.

9. Advise children and others to keep well away

from the lawn mower.

10. Never mow the grass in poor visibility.
11. Remove all loose objects from the lawn before

you start mowing the grass.

6.2 Tips for proper mowing

Important! Never open the chute flap when the
catch bag has been detached (to be emptied) and
the engine is still running. The rotating blade can
cause serious injuries!

Always carefully fasten the chute flap and grass
basket. Switch off the engine before emptying the
grass basket.

Anleitung_RPM_56_S_MS_SPK7:_ 18.07.2011 14:38 Uhr Seite 27