Royal REALE, Instructions For Use Manual

12

5. INSTALLATION

Before lifting the main ON/OFF switch (3) fill the rear water tank under the cup shelf  

(11).

1)

 Remove the coffee machine from its parcking and check that it has not been damaged. 

2)

 Place the appliance on a stable top, close to the mains sockets and water line connections. 

Check that the voltage of  your mains supply corresponds to that indicated in the technical specifica

-

tions.

3)

 Remove the upper cover grid (11), take out the water 

tank (located inside the machine) and rinse it (Photo 1). 

4)

 Fill the tank with approx. 3 litres clean water, put it 

back, connect the water softener and insert the small 
silicone tubes. Close the upper cover grid (11) on the 
machine.

5)

  Before  start-up  the  fitter  must  make  sure  the  ma

-

chine has been properly connected to the electrical and 

earthing systems involved and check the efficiency of  

protection from direct contact. 
In Europe connect the approved cord H05VV-F 3G 1.5 mm with the Schuko plug to the electricity 
supply. 
In USA-Canada connect the approved cord Type SJTO, rated 3x14 AWG, 300 V, 105°C with the 
NEMA 5x15P plug to the electricity supply.

IT IS STRICTLY FORBIDDEN TO USE THE MACHINE WITHOUT EFFEC-
TIVE SAFE EARTHING.

If  the machine is new, it is advisable that you let the water circulate through the system: 

turn the water knob (2) and fill a jug with at least 0.5 litres water.

5a. MACHINE WITH CONNECTION TO THE MAINS 

WATER SUPPLY

If  your machine is to be connected to the mains water supply call a specialized technician, who will 
connect the machine inlet pipe to the water softener (not provided) using the hose (3/8’’) provided. A 
pressure reducer must be installed. Switch on the water softener and check for any leaks.

6. MACHINE IGNITION

Before turning on the machine it is advisable that you check that there is water inside the 
rear tank under the cup shelf  (11).

1)

 Lift the ON/OFF power switch (3).

The red indicator light (4) comes on.

2)

 When the machine is switched on, the electronic 

card checks water level inside the boiler. After ap-

prox. 3 seconds, the filling pump and solenoid valve 

are enabled for filling. 

The coffee machine will automatically be filled with 
water up to the pre-set level (level probe inside the 
boiler).

3)

 When the set level is reached, the pump stops. The 

green warning light (5) comes on and the heating element starts heating the water.