RP LIGHTING 1070W, Installation Manual

5

HANGING THE FAN

STANDARD CEILING 

INSTALLATION

Remember to turn off the power.

 Follow the steps

below to hang your fan properly. 

NOTE: 

This ceiling

fan is supplied with the hanging assemblies; the 
standard ceiling installation using the downrod with
ball and hanger bracket mounting installation.

Step 3. 

Remove the hanger pin, lock pin and set

screws from the top of the motor assembly.

Step 2. 

Secure the waterproof cover and hanger

bracket to the ceiling outlet box with the screws
and washers included with mounting hardware.
(Fig.5)

Step 1. 

Pass the 120-volt supply wires through the

waterproof cover and ceiling hanger bracket as
shown in Fig.5.

Step 4. 

Route wires and safety cable exiting from 

the top of the fan motor through the canopy, coupling 
cover and then through the ball / downrod.(Fig.6)

Step 6. 

Tighten two set screws on top of the fan 

motor firmly.

Step 5. 

Align the holes at the bottom of the downrod

with the holes in the collar on top of the motor housing.
Carefully insert the hitch pin through the holes in the
collar and downrod. Be careful not to jam the pin 
against the wiring inside the downrod. Insert the 
locking pin through the hole near the end of the 
hitch pin until it snaps into its locked position.(Fig.6)

Fig.5

Downrod

Canopy

Set screws

Hitch pin 

Lock pin 

Coupling cover

Safety Cable

Collar

Motor

Fig.6

Wood screws

Ground wire

spring wishers

Hanger bracket

Hanger bracket

screws

Flat washers

Supply wires

120VAC 60Hz

Outlet box

Waterproof

Cover