RP LIGHTING 1072-PC, Installation Manual

5

DOWNROD / BALL ASSEMBLY

HANGING THE FAN MOTOR ASSEMBLY

˙

Lift the fan assembly onto the mounting bracket.

˙

Ensure the notch of the ball joint is positioned on the stopper of the mounting bracket to 

    prevent the fan from rotating when in operation.

Mounting bracket

Stopper of bracket

Notch of ball joint

˙

Locate downrod assembly. Loosen ground

    screw on black hanging ball and setscrew to 
    free lock pin, black hanging ball will slide down.

˙

Remove ground screw and green ground wire.

    Remove hanging ball from downrod and save all parts.

˙

Insert fan wires and safety cable through downrod.

    Thread downrod into top of fan motor housing until 
    holes for downrod pin align with holes in collar.

˙

Make sure wires do not get twisted.

    Insert downrod pin through coupling and 
    downrod, secure by tightening security screw.

˙

Put canopy in between the downrod and ball,

    replace the downrod ball, insert the lock pin
    through downrod  and tight setscrew against
    downrod, tighten ground  wire by using ground screw. 

Warning: 

Failure to tighten setscrew on hanging ball 

completely could result in the fan loose and possibly  falling.

Lock Pin

Set screws

Coupling cover

White wire

Cross bolt

Black Wire

Downrod

Assembly

Blue wire

Green ground wire

Ball screw

Hanging ball

Canopy

Downrod