24
To install the cape or face seal, start by
attaching the cape clips on the sides of
the cape. Make sure the clip goes over
the notch on the helmet and the clip edge
goes into the track around the edge of the
helmet.
FIGURE 10.1
FIGURE 10.2
FACE SEAL/CAPE INSTALLATION/REPLACEMENT
When using a face seal, make sure the
elastic edge is under the users chin at the
front and is in contact all of the way around
the neck and back of the head.
When using a cape, adjust the elastic
cord in the inner collar to ensure a snug
fit around the user’s neck and pull the
fabric down all of the way around over the
shoulders so that it isn’t bunched up.
FIGURE 10.3
FIGURE 10.4
Then press the rubber trim on the cape or
face seal into the track that goes around the
underside of the helmet, making sure the
cape/face seal is completely attached all of
the way around.
SETUP AND CARE - STANDARD CONFIGURATION
CONTINUED
