5
7
A
Fastening the pillars and the base structure
NOTE:
There are two types of pillars: straight and
angle. The straight pillars are placed on the
length of the pool.
The angle pillars are intended to be placed
across the width of the pool.
right pillar
angle pillar
The installation of the structure starts from the corner of the pool
(A)
. Position the abutment correctly as shown in
the picture and then attach the base panel.
For the fixing between the corner pillar
and the right pillar that make up the
corners of the pool, the joints between
the corners are used.
Union between corners
The joints allow to unify the pillars that make up the
corner and the base structure panel.
Then proceed to the placement of the next panel
and make the respective fastening using the screws
provided.
After fixing the 1st base frame panel to the corner pillar,
place the right pillar that completes the corner of the
pool.
Then repeat the same procedure until you get the full
shape of the pool. Before securing to the concrete slab,
check the diagonals and leveling of the structure.
