Valid from: 11/2011
Technical changes reserved
Page 10
Doc.: OM_VIAS & VICD (10D)
Condenser cleaning instructions
Remove air grill / louver in front the condenser.
Remove the dust from the condenser coil; this can be done
with either a brush or a vacuum.
Be careful and don’t bend the lamellas
Replace the air grill panel.
Please assure that the air-in and air-out openings (grille) for ventilation are NEVER blocked!
ATTENTION:
THE LAMELLAS OF THE CONDENSER COIL ARE VERY THIN AND SHARP!
AVOID DIRECT CONTACT TO PREVENT INJURIES!
Glass cleaning instructions
Tilt able front and cover glasses for easy cleaning
(Picture 1 +2)
in- and outside.
ATTENTION
:
Hold glass during opening and cleaning!
Don’t let the glass top fall down – Hold the glass and bring it back in end position!
Front glasses made of insulated double glass
(Picture 3)
are secured via a tight safety cord in end
position, please support glass during opening and cleaning to save the cord!
Don’t underestimate the weight of the glass, we recommend 2 persons for cleaning front and
cover glasses on larger display cases!
Picture 1
Picture 2
Picture 3
CAUTION:
AFTER ALL CLEANING HAS BEEN COMPLETED THE DISPLAY CASE HAS TO
BE RETURNED TO ITS ORIGINAL STATE IN ORDER TO GUARANTEE
EFFICIENT OPERATION!
In addition to daily cleaning, service and maintenance of the display case is required to be
carried out in regular intervals by qualified specialists.
( see Chapter 11 MAINTENANCE )
