- 14 -
M
AGNUM
-OP-EN
INSTALLING DISK PAD DRIVER OR BRUSH:
1. Turn on machine power.
2. Raise the Scrubdeck by depressing the Brush switch
to the up and
OFF
position and turn the machine
power back
OFF
. Remove Key.
3. If the machine is equipped with Jaws, remove pin
(A)
and undo latch
(B)
on front of Jaws to open them
(SEE
BELOW)
.
4. If the machine is equipped with a Shroud, unscrew
Shroud Star Knobs
(C)
and pull Shroud forwards -
Away from the front of the Scrubdeck
(SEE BELOW)
.
5. Attach Brushes or Pads to Motor Drives. Squeeze the
scissor locking device and lift brush up on to the motor
drive hub. Make sure the scissors close and lock on
the brushes
(SEE BELOW)
.
INSTALLING DRIVER PADS:
1. Select the correct Pads that best meet your cleaning
application needs. Consult your local dealer for
assistance.
2. Pad Installation: Attach Pads to Pad Drivers before
connecting drivers to motor hub. Screw center clip
(E)
into place
(SEE BELOW)
.
E
SCRUB BRUSHES / PADS:
There are many different types of brushes available to cover applications from cleaning heavily soiled fl oors to polishing.
A Pad Driver is also available to take advantage of the many cleaning pads on the market. Please refer to the
“Common
Wear Parts”
page to assist in selecting the proper Brush / Pad for the work at hand.
A
B
C
D
