M
AGNUM
-OP-EN
- 17 -
LEVELING P
RO
P
OLISH
DISK DECKS:
NOTICE
All Scrubdeck’s should be level at time of machine
delivery. If machine Scrubdeck is not level - Contact your
Servicing Dealer.
1. Drive machine to a fl at level surface and turn machine
off.
2. Ensure that Scrubdeck is in full upright position.
3. Turn on machine and depress the Brush switch. Just
before the Scrubdeck’s Brushes touch the ground, turn
machine
OFF
.
4. Tip Machine Tank back to gain access to the
Scrubdeck’s Adjustable arms.
5. Loosen the Locking Nut
(A)
on the Adjustable Deck
Arms. Turn the Hexagonal Arm
(B)
on each side of the
Scrubdeck to level it. Use the Scrubdeck Levels
(C)
built onto the deck
(SEE BELOW)
.
6. Extending the Adjustable Arms raise the front and
lowers the rear of the Scrubdeck. After Scrubdeck has
been leveled
(ensure correct pitch backward - if you
have)
- retighten Locking Nuts
(A)
.
LEVELING CYLINDRICAL DECKS:
NOTICE
All Scrubdeck’s should be level at time of machine
delivery. If machine Scrubdeck is not level - Contact your
Servicing Dealer.
1. Drive machine to a fl at level surface and turn machine
off.
2. Ensure that Scrubdeck is in full upright position.
3. Turn on machine and depress the Brush switch. Just
before the Scrubdeck’s Brushes touch the ground, turn
machine
OFF
.
4. Tip Machine Tank back to gain access to the
Scrubdeck’s Adjustable arms.
5. Loosen the Locking Nut
(A)
on the Adjustable Deck
Arms. Turn the Hexagonal Arm
(B)
on each side of the
Scrubdeck to level it. Use the levels built into the deck
(SEE BELOW)
.
6. Extending the Adjustable Arms raise the front and
lowers the rear of the Scrubdeck. After Scrubdeck has
been leveled - retighten Locking Nuts
(A)
.
A
B
A
B
C
