24
Go-Go
V I I . C O M F O R T A D J U S T M E N T S
TILLER ANGLE ADJUSTMENT
WARNING! Remove the key from the key switch before adjusting the tiller. Never attempt to adjust
the tiller while the scooter is in motion.
Your scooter is equipped with an adjustable pivoting tiller.
1. Turn the tiller adjustment knob anticlockwise to loosen
the tiller. See figure 9.
2. Move the tiller to a comfortable position.
3. Turn the tiller adjustment knob clockwise to secure
the tiller in position.
NOTE: In order to lower the tiller to the scooter deck,
you must first remove the seat.
SEAT ROTATION
The seat can be rotated to one of four positions in 90°
increments.
1. Pull up slightly on the seat.
2. Rotate the seat 90° or 180° to the right or left to the
desired position.
3. Lower the seat and be sure it is locked into position.
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to different heights. See
figure 10.
1. Remove the seat from your scooter.
2. Use the attached ring to pull and remove the detent
pin from the lower seat post.
3. Raise or lower the upper seat post to the desired seat
height.
4. While holding the upper seat post at that height, match
up the adjustment holes in the upper and lower seat
posts.
5. Fully insert the detent pin.
6. Replace the seat.
NOTE: The supplied nut, bolt, and washers can be
used as an alternative to the ball detent pin.
Figure 9. Tiller Adjustment
TILLER ADJUSTMENT
KNOB
Figure 10. Seat Height Adjustment
UPPER SEAT POST
LOWER SEAT POST
DETENT PIN
